Remanufacturing CS-400E Cut & Clinch Machine

CS-400E Machine Remanufacturing Process Overview | 1. Machine Evaluation | 2. Machine Disassembly | 3. Rebuild Subassemblies | 4. Reassemble Machine | 5. Machine Calibration and Final Test | 6. Preparation for Shipment | 7. Virtually New Machine at a Lower Cost

STEP 3: Rebuild Subassemblies

3.2 Projector and Microscope subassemblies before and after remanufacturing

Subassemblies are disassembled down to the component state.

Every part is cleaned and re-lubricated if required. Faulty or worn parts are replaced. The subassemblies are rebuilt to original manufacturing standards.

Below you can see two examples of remanufactured subassemblies.