Versatec
Home  »  400E Remanufacturing Process Overview  »  STEP 3: Rebuild Subassemblies  » 3.2 Projector and Microscope Subassemblies

Remanufacturing CS-400E Cut & Clinch Machine

CS-400E Machine Remanufacturing Process Overview  | 1. Machine Evaluation | 2. Machine Disassembly | 3. Rebuild Subassemblies | 4. Reassemble Machine | 5. Machine Calibration and Final Test  | 6. Preparation for Shipment | 7. Virtually New Machine at a Lower Cost

STEP 3:  Rebuild Subassemblies

3.2   Projector and Microscope Subassemblies

  • Subassemblies are disassembled down to the component state.
  • Every part is cleaned and re-lubricated if required.
  • Faulty or worn parts are replaced.
  • The subassemblies are rebuilt to original manufacturing standards.

Below you can see two examples of remanufactured subassemblies.

Projector Assembly
CS-400E Insertion machine, remanufactured projector assembly
disassembled
remanufactured
Optical Correction Microscope Assembly
CS-400E Insertion machine, remanufactured Optical Correction Microscope Assembly
old unit disassembled
remanufactured
Click here to see side-by-side images of the parts before and after remanufacturing.

 

 

  Back to Remanufacturing Process

  Back to STEP 3: Rebuild Subassemblies

TopHome »